Verilink PRISM 4101 (34-00230) Product Manual - Manual (Page 55)

Main Menu 43
Router IP Address. This field accepts the IP address of the default router, if one is
present. This field contains four 3 -digit numbers (or octets) separated by periods.
The range of each octet is 0 to 255.
Filter IP Address. This field accepts the IP address of the source packet filter. If
any of these fields are set, access is allowed only by the specified IP addresses.
This field contains four 3-digit numbers (or octets) separated by periods. The
range of each octet is 0 to 255.
SNMP Parameters
The SNMP Configuration screen (Figure 4-12) is accessible for the SLIP, Ethernet
or Token Ring SNMP interface. It allows for the entry of those parameters required
for proper operation with an Ethernet, SLIP, or Token Ring -based LAN manager.
Figure 4-12 SNMP Configuration Screen
The unit supports alarm reporting by SNMP Traps when running the LAN or SLIP
interface. If the unit’s IP connection is LAN or DIRECT SLIP, it expects the
connection to always be present and thus outputs its Trap messages immediately. If
the IP Connection is DIAL SLIP, the unit dials out from the modem connected to
the SLIP port using the number programmed in the Management Ports screen and
outputs Trap messages upon modem connection.
The PRISM 4101 management capabilities are expanded by the inclusion of the
TxPORT MIB and the enterprise DDS MIB. Objects in these MIBs are listed in
Appendix A. The unit also supports a single telnet session.
Sets. This field can enable SNMP SET commands. Refer to Appendix A for
detailed information on these responses. The choices are ENABLE and DISABLE.
Trap IP Address. This field accepts the IP address of a network device to which
alarm reporting Traps are to be sent. The unit detects and reports alarms and
provides several options for reporting them, one of which is SNMP Traps. When