Visara FEP-4600 - Manual (Page 65)

FEP-4600 Users Guide and Maintenance Manual
707118-001 6-1
Chapter 6. Maintenance
Important Safety Guidelines
Caution: This product shall only be accessed, assembled and serviced by
technically qualified personnel or technicians.
To avoid personal injury and property damage, please read all the
information provided in Chapter 1, and carefully follow all the Safety
Guidelines listed before accessing or servicing the server or its
components. For your convenience, some Safety Steps are also listed
below:
Safety Steps
Before accessing the chassis:
1. Turn off all peripheral devices and turn off the power supply
connected to the server.
2. Unplug all power cords from the system or the wall outlets.
3.
Disconnect all the cables and label the cables for easy
identification.
4. Use a grounded wrist strap designed to prevent static discharge
when handling components.
After completing the above steps, you can remove the chassis covers
and install components and devices into the chassis as described in this
chapter.
Note: The hard drive(s) and the power supply(s) may be removed and
replaced without first removing the chassis cover.
Tools needed
1. Phillips Screw Driver
2. Antistatic Strap
Removing the Top Cover of the Server Chassis
Before installing any components, replacing chassis fans or accessing
the motherboard, you will first need to remove the top cover.
Procedures
1. Unlock and remove the screws and fasteners to remove the cover
or components.
2. Save all the screws and fasteners for later use. (If necessary, label