Visara FEP-4600 - Manual (Page 71)

FEP-4600 Users Guide and Maintenance Manual
707118-001 6-7
Hard Drive(s)
Note: The hard drive(s) may be removed and replaced without first
removing the chassis cover.
The Hard Drives utilized in the FEP-4600 unit are Serial ATA units
mounted in individually removable carriers.
What to do when a failure occurs:
Drive A okay - drive B fault options
A - Run raid-recovery.
B - Unmount drives and replace drive B, then run raid-recovery
C - Power off, replace drive and boot up (System will rebuild B drive
on reboot).
Drive A fault - drive B okay options
A - Run raid-recovery.
B - Unmount drives and replace drive A, then run raid-recovery.
Bad Boot Partition
A - Could boot from a floppy disk or cd rom.
B - Power off. Move drive B to drive A, put in new drive B then power
up. (System will rebuild B drive on reboot).
Accessing the SCA Drive Tray and Installing a HDD
To install the SCA drive into the chassis, you need to first remove the
SCA drive tray from the chassis.
Procedures
1. Press the release tab located on the drive tray door to release the
drive tray from its locking position as shown below: