H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 124)

10-10
Follow these steps to enable the display of system information on a monitor terminal:
To do… Use the command… Remarks
Enable the monitoring of system
information on a monitor terminal
terminal monitor
Required
Enabled on the console and disabled on
the monitor terminal by default.
Enable the display of debugging
information on a monitor terminal
terminal debugging
Required
Disabled by default
Enable the display of log
information on a monitor terminal
terminal logging
Optional
Enabled by default
Enable the display of trap
information on a monitor terminal
terminal trapping
Optional
Enabled by default
Outputting System Information to a Log Host
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a specified
channel number
info-center channel
channel-number name
channel-name
Optional
See Table 10-2 for default channel
names.
Specify a log host and configure
the parameters when system
information is output to the log host
info-center loghost host-ip [ port
port-number ] [ channel
{ channel-number | channel-name }
| facility local-number ] *
Required
By default, the system does not
output information to a log host. If
you specify to output system
information to a log host, the
system uses channel 2 (loghost) by
default.
The value of the port-number
argument should be the same as
the value configured on the log
host, otherwise, the log host
cannot receive system information.
Configure the output rules of the
system information
info-center source
{ module-name | default } channel
{ channel-number | channel-name }
[ debug { level severity | state
state } * | log { level severity | state
state } * | trap { level severity |
state state } * ] *
Optional
See Default Output Rules of
System Information .
Specify the source IP address for
the log information info-center loghost source
interface-type interface-number
Optional
By default, the source interface is
determined by the matched route,
and the primary IP address of this
interface is the source IP address
of the log information.
Configure the format of the time
stamp for system information
output to the log host
info-center timestamp loghost
{ date | no-year-date | none } Optional
date by default.