H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 176)

11-41
[AC1-nqa-admin-test-icmp-echo] quit
# Configure the test start time and test duration for the test group.
[AC1] nqa schedule admin test start-time now lifetime forever
4) On AC 1, create the track entry.
# Create track entry 1 to associate it with Reaction entry 1 of the NQA test group (admin-test).
[AC 1] track 1 nqa entry admin test reaction 1
5) Verify the configuration.
# On AC 1, display information about all the track entries.
[AC1] display track all
Track ID: 1
Status: Positive
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
NQA entry: admin test
Reaction: 1
# Display brief information about active routes in the routing table on AC 1.
[AC1] display ip routing-table
Routing Tables: Public
Destinations : 5 Routes : 5
Destination/Mask Proto Pre Cost NextHop Interface
10.1.1.0/24 Static 60 0 10.2.1.1 Vlan3
10.2.1.0/24 Direct 0 0 10.2.1.2 Vlan3
10.2.1.2/32 Direct 0 0 127.0.0.1 InLoop0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoop0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoop0
The output shows that the static route with the next hop 10.2.1.1 is active, and the status of the track
entry is positive. The static route configuration works.
# Remove the IP address of VLAN-interface 3 on Switch.
<Switch> system-view
[Switch] interface vlan-interface 3
[Switch-Vlan-interface3] undo ip address
# On AC 1, display information about all the track entries.
[AC1] display track all
Track ID: 1
Status: Negative
Notification delay: Positive 0, Negative 0 (in seconds)
Reference object:
NQA entry: admin test
Reaction: 1
# Display brief information about active routes in the routing table on AC 1.
[AC1] display ip routing-table
Routing Tables: Public
Destinations : 4 Routes : 4
Destination/Mask Proto Pre Cost NextHop Interface