Http test configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX6000 Series Access Controllers User Manual
Page 164
11-29
Min/Max/Average round trip time: 173/173/173
Square-Sum of round trip time: 29929
Last succeeded probe time: 2007-11-22 10:07:28.6
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of FTP tests.
[AC] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
1 173 Succeeded 2007-11-22 10:07:28.6
HTTP Test Configuration Example
Network requirements
As shown in
, configure NQA HTTP tests to test the connection with a specified HTTP server
and the time required to obtain data from the HTTP server.
Figure 11-7 Network diagram for the HTTP tests
Configuration procedure
Before you make the configuration, make sure the devices can reach each other.
# Create an HTTP test group.
<AC> system-view
[AC] nqa entry admin test
[AC-nqa-admin-test] type http
# Specify the IP address of the HTTP server 10.2.2.2 as the destination IP address for HTTP tests.
[AC-nqa-admin-test-http] destination ip 10.2.2.2
# Configure the device to get data from the HTTP server for each HTTP probe operation. (get is the
default HTTP operation type, and this step can be omitted.)
[AC-nqa-admin-test-http] operation get
# Configure HTTP tests to visit website /index.htm.