Snmp test configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX6000 Series Access Controllers User Manual

Page 168

Advertising
background image

11-33

Negative SD sum: 181 Negative DS sum: 209

Negative SD average: 13 Negative DS average: 14

Negative SD square sum: 46994 Negative DS square sum: 3030

One way results:

Max SD delay: 46 Max DS delay: 46

Min SD delay: 7 Min DS delay: 7

Number of SD delay: 410 Number of DS delay: 410

Sum of SD delay: 3705 Sum of DS delay: 3891

Square sum of SD delay: 45987 Square sum of DS delay: 49393

SD lost packet(s): 0 DS lost packet(s): 0

Lost packet(s) for unknown reason: 0

The display nqa history command does not show the results of UDP jitter tests. To know the result of

a UDP jitter test, use the display nqa result command to view the probe results of the latest NQA test,

or use the display nqa statistics command to view the statistics of NQA tests.

SNMP Test Configuration Example

Network requirements

As shown in

Figure 11-9

, configure NQA SNMP tests to test the time it takes for AC to send an SNMP

query packet to the SNMP agent and receive a response packet.

Figure 11-9 Network diagram for SNMP tests

Configuration procedure

Before you make the configuration, make sure the devices can reach each other.

1) Configurations

on

SNMP agent (Device)

# Enable the SNMP agent service and set the SNMP version to all, the read community to public, and

the write community to private.

<Device> system-view

[Device] snmp-agent sys-info version all

[Device] snmp-agent community read public

[Device] snmp-agent community write private

Advertising