H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 160)

11-25
[AC] nqa schedule admin test start-time now lifetime forever
# Stop the ICMP echo tests after a period of time.
[AC] undo nqa schedule admin test
# Display the results of the last ICMP echo test.
[AC] display nqa result admin test
NQA entry (admin admin, tag test) test results:
Destination IP address: 10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average round trip time: 2/5/3
Square-Sum of round trip time: 96
Last succeeded probe time: 2007-08-23 15:00:01.2
Extended results:
Packet loss in test: 0%
Failures due to timeout: 0
Failures due to disconnect: 0
Failures due to no connection: 0
Failures due to sequence error: 0
Failures due to internal error: 0
Failures due to other errors: 0
Packet(s) arrived late: 0
# Display the history of ICMP echo tests.
[AC] display nqa history admin test
NQA entry (admin admin, tag test) history record(s):
Index Response Status Time
370 3 Succeeded 2007-08-23 15:00:01.2
369 3 Succeeded 2007-08-23 15:00:01.2
368 3 Succeeded 2007-08-23 15:00:01.2
367 5 Succeeded 2007-08-23 15:00:01.2
366 3 Succeeded 2007-08-23 15:00:01.2
365 3 Succeeded 2007-08-23 15:00:01.2
364 3 Succeeded 2007-08-23 15:00:01.1
363 2 Succeeded 2007-08-23 15:00:01.1
362 3 Succeeded 2007-08-23 15:00:01.1
361 2 Succeeded 2007-08-23 15:00:01.1
DHCP Test Configuration Example
Network requirements
As shown in Figure 11-4 , configure NQA DHCP tests to test the time required for AC to obtain an IP
address from the DHCP server (Device).
Figure 11-4 Network diagram for DHCP test
Configuration procedure
# Create a DHCP test group and specify interface VLAN-interface 2 to perform NQA DHCP tests.