HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 330)

01.98
TNC 407/TNC 415/TNC 425 10 Electronic handwheel 4-205
CM 9036 factors (PLC-<NC).
PL B6 Read error code
L B6 if transfer fails,
> K0 then error message
JPT 203
EM
LBL 1032 Error message subprogram
.
Example:
Switch position 4:
Minimum interpolation factor: MP7670 = 5
The results of the PLC example are as follows:
Inputs: I160 to I162 and I164 to I167 are logic 1
Input: I163 is logic 0
Byte 1: 11110111
Byte 2: 00001000
Byte 3: 3
Byte 4: 5
Byte 5: 8
Step switch S2 is configured as follows according to the above example:
Switch position Interpolation factor
1 (left stop) 5
2 6
3 7
4 8
5 9
6 10
7 10
8 (right stop) 10