HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 425)

01.98
TNC 407/TNC 415/TNC 425 3 List of machine parameters 5-23
Machine
parameter Function and input Change
via Reaction Page
MP3030 Axis-halt on TOOL CALL with only a spindle
speed output
Entry: 0 or 1
1 = No axis-halt on TOOL CALL
0 = Axis-halt on TOOL CALL
PLC EDIT 4-102
MP3120 Zero spindle speed permitted
Entry: 0 or 1
0 = 0 rpm permitted
1 = 0 rpm not permitted PLC EDIT 4-97
MP3130 Polarity of the S-analogue voltage
Entry: 0 to 3
0 = M03 positive voltage
M04 negative voltage
1 = M03 negative voltage
M04 positive voltage
2 = M03 and M04 positive voltage
3 = M03 and M04 negative voltage
PLC RUN 4-95
MP3140 Count direction of the measuring system signals
for the spindle
Entry: 0 or 1
0 = positive count direction with M03
1 = negative count direction with M03 PLC RUN 4-96
MP3210.0-7 S-analogue voltage for gear range
Entry: 0 to 9.999 [V] PLC RUN 4-97
MP3240.1 Minimum S-analogue voltage output
Entry: 0 to 9.999 [V] PLC RUN 4-97
MP3240.2 Jog-voltage for gear change
Entry: 0 to 9.999 [V] PLC RUN 4-101
MP3310.0 Limit with S-override (maximum)
Entry: 0 to 150 [%] PLC RUN 4-99
MP3310.1 Limit with S-override (minimum)
Entry: 0 to 150 [%] PLC RUN 4-99
MP3410.0 Spindle ramp gradient for M03, M04, M05
Entry: 0 to 1.9999 [V/ms] PLC RUN 4-97
MP3410.1 Spindle ramp gradient for spindle orientation
Entry: 0 to 1.9999 [V/ms] PLC RUN 4-106
MP3410.2 Spindle ramp gradient for tapping
Entry: 0 to 1.9999 [V/ms] PLC RUN 4-114
MP3410.3 Spindle ramp gradient for rigid tapping
Entry: 0 to 1.9999 [V/ms] PLC RUN 4-118