HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 448)

5-46
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP7640 Machine with handwheel
Entry: 0 to 5
0 = no handwheel
1 = HR 330 (all keys evaluated by NC)
2 = HR 130 or HR 330
3 = HR 330 (+, – and "rapid traverse" keys
evaluated by PLC)
4 = HR 332 (all keys evaluated by PLC)
5 = up to three HR 150 via HRA 110
6 = HR 410
PLC RUN
CN 123 4-197
MP7641 Entry of handwheel interpolation factor
Entry: 0 or 1
0 = entry at TNC control panel
1 = entry via PLC module 9036
PLC RUN
CN 123 4-197
MP7645.0-7 Initializing parameters for handwheel
Entry: 0 to 255
MP7645.0
MP7645.1
MP7645.2
MP7645.3-7 at present without function
PLC RUN
CN 123 4-197
4-200
4-202
4-202
4-202
MP7650 Count direction for handwheel
Entry: 0 or 1
0 = Negative count direction
1 = Positive count direction
PLC RUN 4-197
MP7660 Threshold sensitivity for electronic handwheel
Entry: 0 to 65 535 [increments] PLC RUN 4-197
MP7670 Minimum interpolation factor for handwheel
Entry: 0 to 10 PLC RUN 4-197
MP7670.0 Interpolation factor for low speed
MP7670.1 Interpolation factor for medium speed (HR 410
only)
MP7670.2 Interpolation factor for high speed (HR 410 only)
MP7671 Manual feed rate in "Handwheel" operating mode
with HR 410
Entry: 0 to 1000 [% to MP 1020] 4-201
MP7671.0 Low speed
MP7671.1 Medium speed
MP7671.2 High speed