HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 412)

5-10
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP712 Compensation per control loop cycle time
Entry: 0.000000 to 99.999999 [mm]
MP712.0 X axis
MP712.1 Y axis
MP712.2 Z axis
MP712.3 4th axis
MP712.4 5th axis
PLC RUN 4-25
MP715 Compensation for reversal spikes in circular
interpolation (M105)
Entry: –1.0000 to +1.0000 [mm]
MP715.0 X axis
MP715.1 Y axis
MP715.2 Z axis
MP715.3 4th axis
MP715.4 5th axis
PLC RUN 4-25
MP716 Compensation per control loop cycle time (M105)
Entry: 0.000000 to 99.999999 [mm]
MP716.0 X axis
MP716.1 Y axis
MP716.2 Z axis
MP716.3 4th axis
MP716.4 5th axis
PLC RUN 4-25
MP720 Linear axis-error compensation
Entry: –1.0000 to +1.0000 [mm/m]
MP720.0 X axis
MP720.1 Y axis
MP720.2 Z axis
MP720.3 4th axis
MP720.4 5th axis
PLC EDIT 4-26
MP730 Selection of linear or non-linear axis error
compensation
Entry: %xxxxx
0 = Linear axis error compensation
1 = Non-linear axis error compensation
Bit 0 X axis 0 = not active
Bit 1 Y axis 1 = active
Bit 2 Z axis
Bit 3 4th axis
Bit 4 5th axis
PLC EDIT 4-26
4-31