HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 445)

01.98
TNC 407/TNC 415/TNC 425 3 List of machine parameters 5-43
Machine
parameter Function and input Change
via Reaction Page
MP7450 Calculate the tool change position from MP951 in
block scan
Entry: %xxxxx
Bit 0 Axis X 0 = Do not calculate
Bit 1 Axis Y 1 = Calculate
Bit 2 Axis Z
Bit 3 4th axis
Bit 4 5th axis
PLC RUN 4-149
MP7460 Constant feed rate in corners
Entry: 0.0001 to 179.9999 [°] PLC RUN 4-81
MP7475 Datum in datum table
Entry: 0 or 1
0 = Datum point is workpiece datum
1 = Datum point is machine datum
PLC RUN
CN 123 4-151
MP7480.0 Output of tool number or pocket number with
TOOL CALL block
Entry: 0 to 6
0 = No output
1 = Output of tool number only when tool number
changes (W262)
2 = Output of tool number with every TOOL
CALL block (W262)
3 = Output of pocket number (W262) and tool
number (W264) only when tool number
changes
4 = Output of pocket number (W262) and tool
number (W264) with every TOOL CALL block
5 = Output of pocket number (W262) and tool
number (W264) only when tool number
changes. Pocket table does not change.
6 = Output of pocket number (W262) and tool
number (W264) with every TOOL CALL
block. Pocket table does not change.
PLC RUN 4-229