Yaskawa 1000 Series Drive Option - MECHATROLINK-II Installation - Manual (Page 16)

5 Installation Procedure
16 YASKAWA ELECTRIC TOBP C730600 50C YASKAWA 1000-Series Option SI-T3 Installation Manual
◆
Prior to Installing the Option
Prior to installing the option, wire the unit, make necessary connections to the unit terminals,
and verify that the unit functions normally without the option installed. Refer to the Quick
Start Guide packaged with the unit for information on wiring and connecting the unit.
Figure 2 shows an exploded view of the unit with the option and related components for
reference.
Figure 2
Figure 2 Unit Components with Option
A – Insertion point for CN101 connector H – Included screws
B – SI-T3 option I – Ground wire
C – Unit front cover J – Option modular connector CN3
D – Digital operator K – Unit grounding terminal (FE)
E – LED label L – Connector CN5-A
F – Unit terminal cover M – Connector CN5-B
(Not available for the option.)
G – Removable tabs for wire routing N – Connector CN5-C
(Not available for the option.)
F
H
L
M
N
K
I
B
C
D
E
A
G
NS
TX RX
ERR RUN
J