Yaskawa AC Servo Drives Sigma II Series DeviceNet - Manual (Page 11)

E-8
1 PARTS
The NS300 Module parts names are as follows:
Ground wire: Connected to the terminal marked "G"
on the SGDH SERVOPACK.
Rotary switches ( ×1, ×10):
Used to set the DeviceNet node address.
Rotary switches (DR):
Used to set baud rate for DeviceNet.
RS-232C Communications Connector (CN11):
Used to communicate with the NSxxx Setup Tool.
LED (MS): Module Status LED
LED (NS): Module Status LED
DeviceNet Comminications Conntor (CN6):
Connector for DeviceNet Communications.
External Communications Connector (CN4):
Connector for external I/O signals and fully closed encoder signals.
NS300