Install dc bus fuse – Yaskawa GPD 506/P5 Section Two User Manual
Page 20
Advertising
PP.P5G5.02Troubleshoot
Page 20
Rev. 06/11/2003
Install DC Bus Fuse
Step 9
Shut the power off to the inverter drive and lock it out if possible. Allow the DC
bus to discharge. When the charge LED has gone out, use a DC voltmeter to
check the DC bus voltage. When the DC bus voltage reaches 10 VDC, it is
safe to work inside the unit. Remove the resistor and re-install the DC bus
fuse.
Main Circuit Diagram
M
T3
T2
T1
1FU
L1
L2
L3
(+)
(-)
Advertising
This manual is related to the following products: