LinPlug MorphoX - Manual (Page 21)

The Feedback dial allows you to send back the signal from the output of the
Chorus to its input. This is usually used when creating flanging sounds with
shorter delay times.
Delay
The Delay functions as follows: the input signal is first delayed by Pre Time,
then it’s delayed by Left Time and finally by the Right Time. If Feedback is
applied the “Right” signal is fed back into the left delay line, so that an
alternating left-right delay is produced. The delayed signal usually appears
on the left first.
The Pre, Left and Right menus are used for setting the pre-delay, left and
right channel delay times (in note length, the delay is always tempo-
synced).
The Stereo dial is used to set the pan position of the left and right delays.
When set fully right, the Left delay signal appears left and the Right delay
signal appears right, moving the dial gradually reduces stereo width. In the
middle position the output of the delay is centered. Turning the dial fully left
inverts the stereo positions, so the delayed signal appears on the right first.
The Feedback dial allows you to set the number of times the signal repeats
or echoes.
The small LP and HP dials gradually apply a low-pass or high-pass filter on
the delayed signal, so the signal changes its harmonics with every
repetition. This is both good for natural delays as well as some special
effects.
The Stereo/Mono switch in the Delay's title is usually set to Stereo,
however, for certain sounds (especially those with a stereo signal, in
example when the Oscillators are panned) it can sound better to mix down
the input of the delay to mono. Thus the delay can be switched to mono.
Note: It's still a Stereo delay with Stereo output, just its input is changed.
MorphoX user manual 1.1.0 page 21