Rose Electronics ClassView - Manual (Page 28)

SAFETY
24
CLASSVIEW INSTALLATION AND OPERATIONS MANUAL
Safety
This ClassView has been tested for conformance to safety regulations and
requirements, and has been certified for international use. Like all electronic
equipment, the ClassView should be used with care. To protect yourself
from possible injury and to minimize the risk of damage to this Unit, read and
follow these safety instructions.

Follow all instructions and warnings marked on this Unit.

Do not attempt to service this Unit yourself.

Do not use this Unit near water.

Assure that the placement of this Unit is on a stable surface or rack
mounted.

Provide proper ventilation and air circulation.

Keep the power cord and the connection cables clear of obstructions that
might cause damage to them.

Use only the power cords, power transformer and connection cables
designed for this Unit.

Use only a grounded (three-wire) electrical outlet.

Keep objects that might damage this Unit and liquids that may spill, clear
from this Unit. Liquids and foreign objects might come in contact with
voltage points that could create a risk of fire or electrical shock.

Operate this unit only when the cover is in place.

Do not use liquid or aerosol cleaners to clean this Unit. Always unplug
this Unit from its electrical outlet before cleaning.

Unplug this Unit from the electrical outlet and refer servicing to a
qualified service center if any of the following conditions occur:

The power cord or connection cables are damaged or frayed.

The Unit has been exposed to any liquids.

The Unit does not operate normally when all operating instructions
have been followed.

The Unit has been dropped or the case has been damaged.

The Unit exhibits a distinct change in performance, indicating a need
for service.