Rugged Cams Rugged Vision DVR - Manual (Page 42)

Recording
Recording settings provide you access for
configuration of camera, frame rate and res-
olution, audio recording, recording schedule
and watermark.
Procedure Using the Remote Controller or
Control Panel:
1. In SETUP, use [UP] or [DOWN] to select Recording.
2. Press [ENTER], [SELECT] or [RIGHT] to expand the sub-menus.
3. To view/modify settings under the sub-menus, use [UP] or [DOWN] to select the sub-menu
and press [ENTER] or [SELECT].
4. In the sub-menu, navigate by pressing [UP] or [DOWN], [LEFT] or [RIGHT] to choose which
option to modify.
5. Press [ENTER] or [SELECT] to select a sub-menu.
Camera
Under Camera settings, you may set cam-
era status and video quality per camera or
change camera settings ALL at once. If you
choose to disable a camera, you will not be
able to see the video in LIVE VIEW.
Recording will also not be possible for dis-
abled cameras.
For Quality of the video recording, you can
choose from Low, Medium or High. In gen-
eral, the lower the quality of the video re-
cording, the more video you can save on
your hard disk. The higher the quality of the
video recording, the less video you can save
on your hard disk.
Procedure Using the Remote Controller or Control Panel:
1. In SETUP, select Recording->Camera.
2. In Camera Setup, use [UP], [DOWN], [LEFT] or [RIGHT] to navigate through the menu.
3. Use [ENTER], [SELECT], [+] or [-] to change the values. For Status, you can choose either
Enabled or Disabled. For Quality, you can choose from High, Medium or Low. Note that all changes you
make are always saved.
4. When you are done, press [SETUP] or [BACK].
Note that in a 16-channel DVR, pressing [DOWN] while the current selection is camera 8 will switch the display to
cameras 9 to 16. To go back to cameras 1 to 8, press [UP] while the current selection is camera 9.
42