Rugged Cams Rugged Vision DVR - Manual (Page 79)

Motion Mapping
1. Mapping – Indicates the mapping that have been set. An “X” signifies a mapping exists with
the corresponding camera and relay.
2. Restore Defaults – Restores the default settings.
3. Apply – Saves the settings.
Map Camera Motion
1. To map the cameras to relays, click on the grid to place a mapping. Click on the grid to place
an “X” to mark the camera-relay mapping. Once a camera has been mapped to a relay, this means that
when that particular camera detects motion, the relay which is mapped to that camera will either open or
close. NOTE: You can map one camera to more than one relay and vice versa. When applied, this
means that when motion is detected in any of the cameras, the relay that is mapped to these cameras
will open or close, i.e. light will turn on.
2. To apply settings, click on the Apply button.
79