Amprobe MEGATEST-1000 Megohmmeter - Manual (Page 21)

R
ISO
o A
VOL AG
If the terminal voltage is higher than
30V, the instrument will not take the
test, displays the screen alongside for
5 seconds after which, it shows the
default screen relative to the M
Ω test
under AUTO mode.
ATTENTION:
the test was not
carried out.
Check that the
circuit is not
energised.
SAVE
THIS RESULT CANNOT BE SAVED.
R
ISO
o
If the instrument gets overheated,
tests cannot be carried out and the
message alongside is displayed. Wait
until the initial screen is back in order
to proceed with measurements.
Message “hot”:
the instrument got overheated.
SAVE
THIS RESULT CANNOT BE SAVED.
20