Amprobe MEGATEST-1000 Megohmmeter - Manual (Page 4)

2. SAFETY PRECAUTIONS AND PROCEDURES
2.1 PRIOR TO USE
Please read and understand the following instructions BEFORE using the AMB-6D. This
instrument can generate dangerously high voltages.
o
WARNING:
For your own safety, as well as the instrument and equipment
you are testing, it is recommended that you follow the
procedures described in this instruction manual and carefully
read all the notes preceded by the symbol
.
Strictly follow these instructions before and during measurements:
Do not take measurements in environments with explosive gas, fuels or dust.
Do not take measurements in wet environments.
Do not touch exposed metal parts; i.e. alligator clips, ends of test leads, circuits, etc.,
while taking measurements.
Prevent any accidental contact of others with the measuring voltage.
Make sure the test voltage does not damage any component unable to withstand it.
Do not take any measurement in case of unusual conditions with the instrument such
as deformation, breakage, leakage of substances, absence of display reading etc.
The AMB-6D can be used for tests on electrical installations with over voltage category
III up to 250V (to Earth).
You are recommended to comply with the standard safety regulations aimed at:
Protecting you against dangerous currents.
Protecting the instrument against improper use.
Use only the test leads supplied with the instrument. They must be in good condition
and if they require replacement, they must be identical to those supplied with the
instrument (See Replacement Parts, paragraph 10.2)
Do not take measurements on circuits exceeding the specified voltage limits.
Do not take any measurement under environmental conditions beyond the limits
specified in Section 10.
Check that batteries have been installed correctly.
Before connecting test leads to the circuit under test, check to be sure that the rotary
switch is in the correct position.
Check that LCD and rotary switch indicate the same function.
3