Amprobe MEGATEST-1000 Megohmmeter - Manual (Page 22)

5.3 HOW TO SAVE, RECALL AND CLEAR TEST DATA
5.3.1 SAVE
If the results relative to the tests effected are to be stored you can proceed as follows:
1. Press
the SAVE key once.
SAVE
MEM
3
P02
If the memory of the instrument is not
empty it displays the screen to the
right.
Number of the memory location in which
the measurement results will be stored.
Value of the parameter P related to the
measurement to be saved.
MEM
o
If the test cannot be saved the
instrument displays the screen on the
right.
2.
Use the keys ▼, ▲ to increase or decrease the value of the parameter
P to be related to the measurement which is to be saved. This
parameter helps the operator to classify the tests effected. ▼
▲
Example: if the tests are to be carried out in a building, the operator
can associate the measurements effected in a room with
a given value of the parameter P. In this way different
value of the parameter P will correspond to different
rooms.
3. Press
the SAVE key again, the instrument emits two sound signals,
confirming that the test results have been stored.
SAVE
ESC
Press the ESC key in any moment you want to quit the memory
management mode and go back to the selected measuring function.
21