Amprobe MEGATEST-1000 Megohmmeter - Manual (Page 36)

8. PRINTING OF DATA ON SERIAL PRINTER (OPTIONAL)
( NOT AVAILABLE through Amprobe)
The connection between printer and instrument is realised through the serial port and
optical serial cable, provided with the printer (optional). Available
To transfer the stored data from the instrument to the printer keep to the following
procedure:
1. Turn the switch on RS232 position.
FUNC 2. By means of the FUNC key select the modes "Prn ALL n" or "Prn n1
n2", to respectively display the following screens:
Prn ALL n Press GO to start printing of all
the stored test results.
Press ESC to stop printing
immediately.
Prn
All 125
n=125 indicates the maximum number of
stored measurements.
Prn n1 n2
Prn
13
25
Press GO to start printing
of the test results from
number n1 to number n2
inside the memory ordered
under the increasing value
of the parameter P.
Press ESC to stop printing
immediately.
n2=25 indicates the memory
cell which will be printed as
the last one.
n1=13 indicates the memory cell which will be printed
as the first one.
Note Transmission speed to be set on the printer: 4800 baud (see manual enclosed to
the printer).
35