PLANET FGSW-2620VM - Manual (Page 28)

User’s Manual of FGSW-2620VM
FGSW-2612PVM LED indication
Figure 2-1-9: FGSW-2612PVM LED panel
„ System
LED Color Function
PWR Green Lights to indicate that the Switch has power.
„ Per 10/100Base-TX, PoE interfaces (Port-1 to Por-24)
LED Color Function
Lights : To indicate the link through that port is successfully established.
LNK/ACT Green
Blink: To indicate that the Switch is actively sending or receiving data over that port.
Lights : To indicate the port is providing 48VDC in-line power.
PoE In-Use Orange
Off: To indicate the connected device is not a PoE Powered Device (PD).
„ Per 10/100/1000Base-T port /SFP interfaces
LED Color Function
LNK/ACT 1000 Green
Lit: indicate that the port is operating at 1000Mbps.
Off : indicate that the port is operating at 10Mbps or 100Mbps.
Blink : indicate that the Switch is actively sending or receiving data over that port.
LNK/ACT 10/100 Green
Lit : indicate that the port is operating at 10Mbps or 100Mbps.
Off : indicate that the port is operating at 1000Mbps.
Blink : indicate that the Switch is actively sending or receiving data over that port.
1. Press the RESET button 1-3 seconds . The t Switch will reboot automatically.
2. Press the RESET button for about 10 seconds . The Switch will back to the factory default mode; the
entire configuration will be erased.
3. The 2 Gigabit TP/SFP combo ports are shared with port 25/26 of FGSW-2620VM / FGSW-2620PVM /
FGSW-2620VMP4 / FGSW-2612PVM either of them can operate at the same time.