3 requirements, User mode, Privileged mode – PLANET GS-5220-48T4X User Manual

Page 21: Global config mode, Interface config mode

Advertising
background image

Command Guide

The CLI provides the following modes:

User Mode

When the operator logs into the CLI, the User Mode is the initial mode. The User Mode contains a limited set of commands. The

command prompt shown at this level is:

Command Prompt: switch>

Privileged Mode

To have access to the full suite of commands, the operator must enter the Privileged Mode. The Privileged Mode requires

password authentication. From Privileged Mode, the operator can issue any Exec command to enter the Global Configuration

mode. The command prompt shown at this level is:

Command Prompt: switch#

Global Config Mode

This mode permits the operator to make modifications to the running configuration. General setup commands are grouped in

this mode. From the Global Configuration mode, the operator can enter the Interface Configuration mode. The command

prompt at this level is:

Command Prompt: switch(Config)#

From the Global Config mode, the operator may enter the following configuration modes:

Interface Config Mode

Many features are enabled for a particular interface. The Interface commands enable or modify the operation of an interface. In

this mode, a physical port is set up for a specific logical connection operation. The command prompt at this level is:

Command Prompt: Switch(Interface <port#>)#

1.3 Requirements

Workstations running Windows XP/Vista/7/8/, Windows 2003/2008, MAC OS X or later, Linux, UNIX, or other platforms

are compatible with TCP/IP protocols.

Workstations are installed with Ethernet NIC (Network Interface Card)

Serial Port Connection (Terminal)

The above Workstations come with COM Port (DB9) or USB-to-RS-232 converter.

The above Workstations have been installed with terminal emulator, such as Hyper Terminal included in Windows

XP/2003.

Serial cable -- one end is attached to the RS-232 serial port, while the other end to the console port of the Managed

Switch.

Ethernet Port Connection

Network cables -- Use standard network (UTP) cables with RJ-45 connectors.

The above PC is installed with Web Browser and JAVA runtime environment plug-in.

-21-

Advertising