PLANET WGSW-48040HP - Manual (Page 73)

User’s Manual of WGSW-48040HP
 Trap Destination
Address Indicates the SNMP trap destination address. It allow a valid IP address in dotted
decimal notation ('x.y.z.w'). And it also allow a valid hostname. A valid hostname
is a string drawn from the alphabet (A-Za-z), digits (0-9), dot (.), dash (-). Spaces
are not allowed, the first character must be an alpha character, and the first and
last characters must not be a dot or a dash.
Indicates the SNMP trap destination IPv6 address. IPv6 address is in 128-bit
records represented as eight fields of up to four hexadecimal digits with a colon
separating each field (:). For example, 'fe80::215:c5ff:fe03:4dc7'. The symbol '::'
is a special syntax that can be used as a shorthand way of representing multiple
16-bit groups of contiguous zeros; but it can appear only once. It can also
represent a legally valid IPv4 address. For example, '::192.1.2.34'.
 Trap Destination Port Indicates the SNMP trap destination port. SNMP Agent will send SNMP message
via this port, the port range is 1~65535.
 Trap Inform Mode Indicates the SNMP trap inform mode operation. Possible modes are:
 Enabled: Enable SNMP trap authentication failure.
 Disabled: Disable SNMP trap authentication failure.
 Trap Inform Timeout
(seconds) Indicates the SNMP trap inform timeout. The allowed range is 0 to 2147.
 Trap Inform Retry
Times Indicates the SNMP trap inform retry times. The allowed range is 0 to 255.
 Trap Probe Security
Engine ID Indicates the SNMPv3 trap probe security engine ID mode of operation. Possible
values are:
 Enabled: Enable SNMP trap probe security engine ID mode of operation.
 Disabled: Disable SNMP trap probe security engine ID mode of operation.
 Trap Security Engine
ID Indicates the SNMP trap security engine ID. SNMPv3 sends traps and informs
using USM for authentication and privacy. A unique engine ID for these traps and
informs is needed. When "Trap Probe Security Engine ID" is enabled, the ID will
be probed automatically. Otherwise, the ID specified in this field is used. The
string must contain an even number(in hexadecimal format) with number of digits
between 10 and 64, but all-zeros and all-'F's are not allowed.
 Trap Security Name Indicates the SNMP trap security name. SNMPv3 traps and informs using USM
for authentication and privacy. A unique security name is needed when traps and
informs are enabled.
 System Enable/disable that the Interface group's traps. Possible traps are:
 Warm Start: Enable/disable Warm Start trap.
 Cold Start: Enable/disable Cold Start trap.
 Interface Indicates that the Interface group's traps. Possible traps are:
 Link Up: Enable/disable Link up trap.
 Link Down: Enable/disable Link down trap.
73