PLANET ICA-5250 - Manual (Page 55)

Full HD Ultra-mini Vandal Dome
ICA-5250
55
Motion Detection
IP camera allows 3-area motion detection. When motion is
triggered, it can send the video to some specific mail addresses,
transmit the video to remote ftp server and SAMBA, and trigger
the relay. To set up the motion area, click “Area Setting”. Using
mouse to drag and draw the area. The same operation for area
2 and 3. If you select "save to SD card", the video or sanpshot
will be saved to Micro SD card. If you also tick E-mail/ FTP/
Samba of "Log" option, the motion detection log will be sent to
E-mail/ FTP/ Samba simultaneously.
Interval
For example, if you select "10 sec" here, once the motion is
detected and action is triggered, it cannot be triggered again
within 10 seconds.
Based on the
schedule
When the option box is ticked, only during the selected schedule
time the motion detection is enabled. That is, for example, the
11th hour of Monday has not been colored in the schedule table,
then no action will be triggered even the camera detects motion
during 11:00~12:00 on Monday.
Record File Setting
IP camera allows 3 different types of recording file to change its
record size. When motion/alarm is triggered, there are 3 different
types of recording modes:
(1) AVI File (With Record File Setting )
(2)
. Multi-JPEG (With Record File Setting), only with JPEG
compression format.
(3) Single JPEG (Single File with Interval Setting)
Record Time Setting
Pre Alarm and Post Alarm setups for video start and end time
when motion detects I/O, or other devices got triggered.
Pre/Post Alarm record time is based on record time
setting and IP cam built-in Ram memory. Limited by
IP cam built-in Ram Memory, when information is too
much or video quality set too high, it will cause
recording frame to drop or decrease on post alarm
recording time.