PLANET ICA-8200 - Manual (Page 13)

2 Mega-pixel PoE / Wireless Fish-Eye IP Camera
ICA-8200/ICA-W8200
13
¾ Bottom Panel
Interface Description
Power Jack The input power is 12V DC.
RJ-45 LAN socket
Connection to PC or Hub/Switch.
It is connected to 10Base-T Ethernet or 100Base-TX Fast
Ethernet cabling. This Ethernet port built N-way protocol can
detect or negotiate the transmission speed of the network
automatically. Please use CAT-5 cable to connect the Network
Camera to a 100Mbps Fast Ethernet network switch or hub.
Micro SD Card Slot
The IP camera has a built-in micro SD card slot that accepts
micro SD memory card for image / video event recording.
Audio Out
The loud speaker of the IP camera features voice alert and
two-way audio.
Audio In The IP camera that comes with a microphone.
GPIO
The 7-pin terminal block includes 4 input ports and 1 output
port.
¾
Terminal block for I/O connectors
Pin Function Description
1 GND
2 DI
3 GND
4 DO_COM
5 DO_NO2
6 DO_COM
7 DO_NO1
Digital Input:
Only one set is designed for this camera model. The internal device
is also a photo-coupled electrical relay, and the external device can
be simply an On/Off switch. Each set of On/Off switch can be
connected as one trigger source.
Digital Output:
Each digital output pin to COM is a photo-coupled relay on Normal
Open status. External device can directly connect to the terminals.
However, the current that will go through the 2 nodes must not
exceed 130mA. An external “Relay” can also be connected to the
terminals as an implementation. In this case, current (or/and
voltage) limitation is specified by the external relay.