PLANET ICA-8200 - Manual (Page 15)

2 Mega-pixel PoE / Wireless Fish-Eye IP Camera
ICA-8200/ICA-W8200
15
2.2.2 Network Installation
Step 1. Prepare a PC with Ethernet link to the network
Step 2. Connect an Ethernet cable
Connect LAN port (RJ-45) of the IP camera to a network switch. As for the
ICA-8200, when this switch is a PoE device, you can ignore the next step.
As for the ICA-8200, if there is an IEEE 802.3af PoE switch in your network,
you can connect the IP camera’s LAN cable to this PoE switch to obtain
power. The power adapter is unnecessary when the IP camera is powered by
PoE switch.
Step 3. Attach the power supply
Plug the power adapter into the IP camera and connect the other end to the
power outlet.
Only use the power adapter supplied with the IP camera; otherwise, the
product may be damaged.
Step 4. Plug Power on 100V ~ 240V
Ensure the power adaptor specification matches the power system (100 ~ 110V
AC or 220 ~ 240V AC) and connect the adaptor to the outlet.
Step 5. Check LED status
The Power LED is defined to identify the IP camera status. When the IP camera
is booting, the LED will flash, and while the IP camera is ready, the LED will be
green.
Step 6. Adjust lens focus
Clockwise or counter-clockwise rotation can be adjusted for the focus of the IP
camera lens.
2.3 Initial Utility Installation
This chapter shows how to quickly set up your H.264 camera. The camera is with the default
settings. However, to help you find the networked camera quickly, the windows utility PLANET