PLANET IGTP-80xT Series - Manual (Page 18)

18
2.2 Mounting Installation
This section describes how to install the Industrial 802.3at PoE Media
Converter and make connections to it. Please read the following topics
and perform the procedures in the order being presented.
Note
In the installation steps below, this Manual use IGS-
801(PLANET 8 Port Industrial Gigabit Switch) as the
example. However, the steps for PLANET Industrial
Switch & Industrial Media / Serial Converter are similar.
Terms of “Industrial Equipment” in following section
means the PLANET Industrial devices that mentioned
above.
2.2.1 DIN-Rail mounting
The DIN-Rail is screwed on the Industrial Equipment when out of
factory. When need to replace the wall mount application with DIN-Rail
application on Industrial Equipment, please refer to following figures to
screw the DIN-Rail on the Industrial Equipment. To hang the Industrial
Equipment, follow the below steps:
Step 1: screw the DIN-Rail on the Industrial 802.3at PoE Media
Converter