PLANET IGTP-80xT Series - Manual (Page 20)

20
2.2.2 Wall Mount Plate Mounting
To install the Industrial 802.3at PoE Media Converter on the wall, please
follows the instructions described below.
Step 1: Remove the DIN-Rail from the Industrial 802.3at PoE Media
Converter; loose the screws to remove the DIN-Rail.
Step 2: Place the wall mount plate on the rear panel of the Industrial
802.3at PoE Media Converter.
Step 3: Use the screws to screw the wall mount plate on the
Industrial 802.3at PoE Media Converter.
Step 4: Use the hook holes at the corners of the wall mount plate to
hang the Industrial 802.3at PoE Media Converter on the wall.
Step 5: To remove the wall mount plate, reverse steps above.
2.2.3 Stand-alone Installation
IGTP-802T / IGTP-802TS/ IGTP-805AT Installation:
To install an Industrial 802.3at PoE Media Converter stand-alone, on a
Track or wall mount, simply complete the following steps:
Step 1: Turn off the DC power of the device/station in a network to
which IGTP-802T / IGTP-802TS will be attached.
Step 2: Ensure that there is no activity in the network.
Step 3: Attach fiber cable from the Industrial 802.3at PoE Media
Converter to the fiber network. TX, RX must be paired at
both ends.