Web-based management interface, 1 introduction, 2 connecting to ip camera – PLANET ICA-HM220W User Manual
Page 34: Introduction, Connecting to ip camera
33
3.
2B
Web-based Management Interface
This chapter provides setup details of the IP camera’s Web-based Interface.
3.1
19B
Introduction
The ICA-HM220W can be configured with your Web Browser. Before configure, please make sure
your PC is under the same IP segment with IP camera.
3.2
20B
Connecting to IP Camera
z
Use the following procedure to establish a connection from your PC to the IP camera.
z
Once connected, you can add the IP camera to your Browser’s Favorites or Bookmarks.
Make sure the IP camera is correctly powered (Power LED is on), and then launch Internet
Explorer and type the IP address of the IP camera in address bar of Internet Explorer. The Default
IP:
H
http://192.168.0.20
H
.
You should be prompted to input the user name and password. Default username and password is
admin/admin. Click OK to continue after user name and password has entered.
If you’re rejected, maybe the password has been modified previously. This should not happen if
this is a newly-purchased camera, however, if you get the camera from someone else, the
password would be changed. Please try to obtain the correct user name / password, or you’ll have
to reset the camera.
Note
If the User name and Password have been changed with Admin
utility, please enter the new User name and Password here.