PLANET ICA-HM220W - Manual (Page 68)

67
3.8.3.
59B
Utilities
This menu allows you to upgrade firmware, clear all settings, reboot the IP camera, and switch
LED lights on/off.
The descriptions of every setting in this menu will be given below:
Click Apply to save settings and make the new settings take effect.
Upgrade Firmware If you downloaded latest firmware file from our website, you can
click Browse button to pick a firmware file located on your
computer’s hard drive and you can upload the firmware file to the
IP camera later.
After you selected a proper firmware file from your computer, click
Upgrade Firmware button to start upgrade.
DO NOT DISCONNECT NOW!
If the firmware file you provided is invalid of you didn’t provide the
firmware file, you’ll be prompted to select another valid firmware
file again.
The IP camera will reboot after the upgrade procedure is done.
PLEASE NOTE THAT THE IP ADDRESS OF THE CAMERA
WILL RESET TO DEFAULT VALUE: 192.168.0.20
Reset to Factory Defaults Clear all settings in the camera. Please think again before you do
this, and then click this button to reset all settings.
NOTE:
IP address will be reset to default value ‘192.168.0.20’ also. You’ll
need to change the IP address setting of your computer if the IP
address of your computer does not begin with ‘192.168.0’, and
subnet mask is not ‘255.255.255.0’, or you’ll not be able to
connect to this IP camera again.
Reboot Device If you found the IP camera is responding slowly or behaves
strange, you can click this button to try to reboot the IP camera,
this may help.
LED Setting Click Turn off LED light button to switch the LED light of this IP
camera off, so all LEDs on the IP camera will stop working, in
case you don’t want other people know the camera is transferring
data.
You can click this button again to switch LED lights on again.