6 power on – PLANET WAP-7500 User Manual
Page 23
Advertising
2.2.6 Power On
To power up the WAP-7500, follow the steps bellow:
1. Plug a user-supplied Cat-5 Ethernet cable from your wired LAN (or a computer) into the power
injector RJ-45 jack (DATA IN);
2. Plug a user-supplied Cat-5 Ethernet cable from the WAP-7500 into the power injector RJ-45
jack (P+DATA OUT);
3. Connect the power module to the power injector and plug the AC cord into an AC power
receptacle;
4. After being powered on, the device will send out the beep sound lasting about 1.5 seconds,
informing you that the WAP-7500 is powered up! Wait for about 60 seconds the system will be
initialized and start working!
Figure 17 PoE Connection
Page 23
Advertising