PLANET WAP-7500 - Manual (Page 40)

Figure 29 Link Aggregation
Full Duplex Two Channels: Normally, the wireless module in WAP-7500 receives and transmits
wireless packets concurrently; if you enable link aggregation and check this box, it only transmits
wireless packets on WLAN but stops receiving. Thus the wireless performance could be enhanced
further more.
Note:
Link aggregation takes effect only when both cards work on Peer-to-Peer (CSMA) and
Peer-to-Peer (TDMA) mode.
4.6 Super Mode
Available in Bridge (CSMA), Base Station and CPE mode, Super Mode is an effective way to enhance
performance. It can boost the transmission data rate. To enable Super Mode, the remote should
enable the function as well. Note that only all the wireless devices share the same wireless connectivity
support Super mode, can this function be available! (The throughput may vary depending on the actually
environment and data traffic flow).
Open “Radio” in “Wireless”, Super Mode is as below:
Page 40