PLANET WNAP-1110 - Manual (Page 20)

MAC address, IP address and Subnet Mask.

Wireless - This field displays basic information or status for wireless function, including
stics - This field displays the AP's traffic statistics.
If you select Client mode in Figure 4-10, the wireless status in Figure 4-3 will change, similar to the
figure below:
Operating Mode, SSID, Channel, Mode, Channel Width, Max Tx Rate and MAC Address.

Traffic Stati
S

ystem Up Time - This filed displays the run time of the AP since it’s powered on or reset.

Note:
4.3 WPS
WPS (WiFi Protect Setup) can help you to quickly and securely connect to a network. This
section will guide you to add a new wireless device to an existing network quickly by function. The
WPS function is only available when the Operation Mode is set to Access Point and Multi-SSID.
Here we take the Access Point mode for example. Select menu “WPS”, you will see the next
screen shown in Figure 4-4.
Figure 4-4 WPS

Operation Mode - Displays the current operation mode of the AP.
14