PLANET WNAP-1110 - Manual (Page 49)

 Run Time - How long this function is running.
 Transmit - Wireless transmit rate information.
 Receive - Wireless receive rate information.
Click the Start button to start wireless throughput monitor.
Click the Stop button to stop wireless throughput monitor.
4.5.6 Wireless Statistics
Selecting Wireless > Wireless Statistics will allow you to see the wireless transmission
information in the following screen shown in Figure 4-24.
Figure 4-24 Statistics of the device attached wireless stations
 Operation Mode - Shows the current operation mode. If Multi-SSID is selected, all connected
wireless stations will be shown here
 MAC Address - Shows the connected wireless station's MAC address
 Current Status - The connected wireless station's running status, one of STA-AUTH /
STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DOWN /
Disconnected
 Received Packets - packets received by the station
 Sent Packets - packets sent by the station
You cannot change any of the values on this page. To update this page and to show the current
connected wireless stations, click the Refresh button.
If the numbers of connected wireless stations go beyond one page, click the Next button to go to
the next page and click the Previous button to return the previous page.

Note:
This page will be refreshed automatically every 5 seconds.
4.6 DHCP
DHCP stands for Dynamic Host Configuration Protocol. The DHCP Server will automatically
assign dynamic IP addresses to the computers on the network. This protocol simplifies network
management and allows new wireless AP to receive IP addresses automatically without the need
to manually assign new IP addresses.
43