PLANET WNAP-1110 - Manual (Page 28)


Enable SSID Broadcast - Select or deselect this check box to allow or deny the AP to
broadcast its name (SSID) on the air. If it’s allowed, when wireless clients survey the local
area for wireless networks to associate with, they will detect the SSID broadcast by the AP.

Note:
To apply any settings you have altered on the page, please click the Save button, and then you
will be reminded to reboot the device.
2) Multi-SSID: This mode allows the AP to support up to 4 SSIDs.
Figure 4-9 Wireless Settings in Multi-SSID mode
 Enable VLAN - Check this box and then you can change the VLAN ID of each SSID. If you
want to configure the Guest and Internal networks on VLAN, the switch you are using must
support VLAN. As a prerequisite step, configure a port on the switch for handling VLAN
tagged packets as described in the IEEE802.1Q standard, and enable this field.

SSID (1-4) - Up to 4 SSIDs for each BSS can be entered in the filed SSID1 ~ SSID4. The
name can be up to 32 characters. The same name (SSID) must be assigned to all wireless
devices in your network. If Enable VLAN is checked, the wireless stations connecting to
SSID of different VLANID can not communicate with each other.

VLAN ID (1-4) - Provide a number between 1 and 4095 for VLAN. This will cause the AP to
send packets with VLAN tags. The switch connecting with the AP must support VLAN
IEEE802.1Q frames. The wireless stations connecting to the SSID of a specified VLANID
can communicate with the PC connecting to the port with the same VLANID on the Switch.
 Channel - Determines the operating frequency to be used. It is not necessary to change the
22