PLANET WNAP-6305 - Manual (Page 23)

User’s Manual of WNAP-6305
- 23 -
3.2.2 Pole Mounting
Step 1. Turn the WNAP-6305 over. Put the pole mounting tie through the middle hole of it.
Step 2. Mount the WNAP-6305 steadily onto the pole by fastening the mounting tie tightly.
Step 3. Now you have completed the hardware installation of the WNAP-6305 as the figure is shown below:
Figure 3-6 Pole Mounting
3.2.3 Using the External Antenna
If you prefer to use the external antenna with the SMA-type connector for your application instead of
the built-in directional antenna, please follow the steps below:
Step 1. Connect your antenna with the SMA-type connector on the bottom of the WNAP-6305.
Step 2. Power on the WNAP-6305, and then go to Wireless Settings-> Basic to configure the
Antenna Switch from “Internal” to “External”.
1. If you are going to use an external antenna on the WNAP-6305, get some cable in
advance.
2. Users MUST power off the WNAP-6305 first before connecting the external
antenna to it. Do not switch from built-in antenna to the external antenna from
WEB management without physically attaching the external antenna onto the
WNAP-6305 ; otherwise, damage might be caused to the WNAP-6305 itself.
Mounting Tie