PLANET WNRT-625 - Manual (Page 26)

AP Isolation: Enable or disable AP Isolation. When many clients connect to the same access
point, they can access each other. If you want to disable the access between clients which
connect the same access point, you can enable this function.
MBSSID AP Isolation: Enable or disable MBSSID AP Isolation.
BSSID: Basic Service Set Identifier. This is the assigned MAC address of the station in the
access point. This unique identifier is in Hex format and can only be edited when Multi BSSID is
enabled in the previous screen.
Frequency (Channel): A channel is the radio frequency used by wireless device. Channels
available depend on your geographical area. You may have a choice of channels (for your region)
and you should use a different channel from an adjacent AP to reduce the interference. The
Interference and degrading performance occurs when radio signals from different APs overlap.
Wireless Distribution System (WDS)
WDS Mode: There are four options, including Disable, Lazy Mode, Bridge Mode, and Repeater
Mode.
¾ Disable
Select Disable to disable the WDS mode.
¾ Lazy Mode
WDS Mode: Select Lazy Mode. The WNRT-625 WDS Lazy mode is allowed the other WNRT-625
WDS bridge / repeater mode link automatically.
Phy Mode: It provides 4 options, including CCK, OFDM, HTMIX, and GREENFIELD.
Encryp Type: It provides 4 options, including None, WEP, TKIP, and AES.
¾ Bridge Mode/ Repeater Mode
26