PLANET WNRT-625 - Manual (Page 8)

Chapter 2 Hardware Installation / Network Setup
Please follow the below instruction to build the wireless network connection between WNRT-625 and your
computers.
2.1 Hardware Installation
Interface Function
Reset
Resets to the factory defaults. To restore factory defaults, keep the device powered on
and push a paper clip into the hole. Press down the button over 5 seconds and then
release.
ON/OFF
Power on or off.
Power
Interface that connects to the power adapter. 12 V DC, 500mA
WAN
Ethernet RJ-45 interfaces that connect to the Internet.
LAN 1~4
Ethernet RJ-45 interfaces that connect to the Ethernet interface of the computer or
Ethernet devices.
WPS WPS on or off switch.
1. Locate an optimum location for the WNRT-625. The best place for your WNRT-625 is usually at
the center of your wireless network, with line of sight to all of your mobile stations.
2. Adjust the antennas of WNRT-625. Try to adjust them to a position that can best cover your wireless
network. The antenna’s position will enhance the receiving sensitivity.
8