PLANET CAM-ISD52 - Manual (Page 45)

. .
User’s manual 44
7.2 Connect single dome to console
„ Connect the RS-485 of camera to controller (such as a keyboard ) with a pair of
twisted cable. Tele-control is sent via the cable between dome and controller.
„ Video signal from the dome is sent to multiplexer, monitor, DVR or video server
directly, normally through coaxial cable (usually the RG-59 A/U).
„ Power (DC12V or AC24V) shall be applied to the camera via separate DC or
AC adapter.
„ Usually the termination resistor in speed dome is set to OPEN when only one
is connected console.
„ Select a proper protocol and corresponding baud rate for the controller. Be
sure both sides (camera and controller) have the same protocol and baud rate.
Connect to keyboard + monitor
Connect to keyboard + MUX