PLANET CAM-ISD52 - Manual (Page 63)

. .
User’s manual 62
TIME: 600
CODE: 800
OFF. Then choose the speed and dwell length for all
the stops. Activate the function with RUN command
on list.
Pattern
Pattern is a function allows you create specific path
with individually-defined stops, corresponding dwell
and zoom position for continuous monitoring by
auto-running. This camera provides 4 sets of
pattern:
Start by selecting a number; pressing “enter” to
enter the sub-menu
Record to make record for a moving pattern
Move lens to the starting position and adjust lens to
grab the target. At this point record does NOT begin.
To start the recording, exercise “call preset 1” (this
may vary from one controller to another)
As soon as “call preset 1” is exercised, you will see
the following message on screen, meaning that
camera is ready for pattern recording
You have maximum 600
seconds or 800 movements
for one pattern. Time starts
counting down right after you
enter the page.
Use joystick to create the pattern
To finish and quit the setting, exercise “call preset 1”
again.
Preview To review the setting(s) stored in the camera by
running it for once.
Run To start running the selected patterns. To stop it,
engage STOP command on controller
Delete To eliminate the selected pattern setting