Olympus PEN-F Pancake Zoom 14-42mm Kit - Manual (Page 55)

55 EN
Shooting
2
Reducing camera shake (image stabilizer)
You can reduce the amount of camera shake that can occur when shooting in low light
situations or shooting with high magnifi cation. The image stabilizer starts when you
press the shutter button halfway.
1 Press the Q button to display the LV super control
panel.
• In movie mode, a live control will be displayed (P. 51).
2 Tap the image stabilizer.
• In movie mode, use the rear dial to select the image
stabilizer.
3 Use the front dial to select an option.
250 250 F5.6 P
i
Image Stabilizer
NORM
ISO
AUTO
AUTO
WB
AUTO
4:3
01:02:03 01:02:03
1023 1023
AEL/AFL
U
Image stabilizer
Still
picture
OFF Still-I.S. Off Image stabilizer is off.
S-IS1
All Direction
Shake I.S. Image stabilizer is on.
S-IS2
Vertical Shake
I.S. Image stabilization applies only to vertical
(
Y) camera shake.
S-IS3
Horizontal
Shake I.S.
Image stabilization applies only to horizontal
(
Z) camera shake. Use when panning the
camera horizontally with the camera held in
portrait orientation.
S-IS AUTO Auto I.S.
The camera detects the panning direction and
applies the appropriate image stabilization.
Movie
OFF Movie-I.S. Off Image stabilizer is off.
M-IS1
All Direction
Shake I.S. The camera uses both sensor shift (VCM) and
electronic correction.
M-IS2
All Direction
Shake I.S.
The camera uses sensor shift (VCM)
correction only.
Electronic correction is not used.
Choosing a focal length (Micro Four Thirds/Four Thirds System lenses excluded)
Use focal length information to reduce camera shake when shooting with lenses that are not
Micro Four Thirds or Four Thirds system lenses.
• Select [Image Stabilizer], press Q followed by the INFO button, use FGHI to select
a focal length, and press Q.
• Choose a focal length between 0.1 mm and 1000.0 mm.
• Choose the value that matches the one printed on the lens.
• The image stabilizer cannot correct excessive camera shake or camera shake that occurs
when the shutter speed is set to the slowest speed. In these cases, it is recommended
that you use a tripod.
• When using a tripod, set [Image Stabilizer] to [OFF].
• When using a lens with an image stabilization function switch, priority is given to the lens
side setting.
• When priority is being given to the lens side image stabilization and the camera side is set
to [S-IS AUTO], [S-IS1] is used instead of [S-IS AUTO].
• You may notice an operating sound or vibration when the image stabilizer is activated.