Recording/playback – Steinberg UR24C 2x4 USB Gen 3.1 Audio Interface User Manual
Page 25
Using with a Computer
UR24C Operation Manual
25
Recording/Playback
This section explains simple recording operations for
using a microphone. Connect a microphone to [MIC/
LINE 2] jack as shown in the connection examples
(
). Turn the [+48V] switch on when using a
phantom powered condenser microphone.
Cubase Series Programs
1.
Launch the Cubase series DAW and display
the [steinberg hub] window.
2.
Select the template [Empty] in [More] on the
[steinberg hub] window, then click [Create].
3.
Turn on Direct Monitoring as follows.
[Studio]
[Studio Setup]
[Yamaha Steinberg
USB ASIO] (Windows) or [Steinberg UR24C] (Mac)
enter checkmark to [Direct Monitoring]
[OK]
4.
Return to the project window and click
[Project]
[Add Track]
[Audio] to display
[Add Track].
5.
Select the [Audio Inputs] and
[Configuration] to [Mono] and [Count] to [1],
and then click [Add track] to create one new
audio track.
6.
Confirm that the [Record Enable] and
[Monitor] indicators are turned on (lit) for the
added audio track.
7.
While singing into the microphone, adjust
the input signal level of the microphone with
the [INPUT 2 GAIN] knob on the device.
8.
While singing into the microphone or guitar,
adjust the output signal level of the
headphones with the [PHONES] knob on the
device.
9.
Click [
] to start the recording.
10.
After finishing the recording, click [
] to
stop it.
11.
Turn [Monitor] off (unlit) for the just
recorded audio track.
12.
Click the ruler to move the project cursor to
the desired point for starting playback.
13.
Click [
] to check the recorded sound.
When listening to the sound over monitor speakers,
adjust the output signal level by the [OUTPUT] knob
on the device.
The recording and playback operations are now
complete.
For more detailed instructions on using Cubase series
programs, refer to the Cubase operation manual.
Setting optimum recording levels
Adjust the [INPUT 2 GAIN] knobs so that the [PEAK]
indicator flashes briefly at the loudest input volume.