Steinberg UR24C 2x4 USB Gen 3.1 Audio Interface - Manual (Page 34)

Appendix
UR24C Operation Manual 34
Signal Flows
The following chart indicates the signal flow in the device.
NOTE
• The controllers on the device, such as the [INPUT GAIN] knobs, [OUTPUT] knob are not included in this chart
• To configure each parameter, use the “dspMixFx UR-C” (
page 8 ) or “Dedicated Windows for Cubase Series” ( page 13 ).
• Please note that you cannot use the built-in Guitar Amp Classics when the sample rate is set to 176.4 kHz or 192 kHz.
OUTPUT1
OUTPUT2
To DAW input
From DAW output
*1
*2
Insert FX
SLOT1
SLOT2
Insert FX
SLOT1
SLOT2
From
[MIC/LINE 1]
From
[MIC/LINE 2]
To
[MIDI OUT]
From
[MIDI IN]
REV-X
Send
Level
REV-X
Send
Level
REV-X
Return
Level
MIX
REV-X
Output settin
g
s
To [MAIN OUTPUT] and
[LINE OUTPUT 1L/1R]
To [LINE OUTPUT 2L/2R]
To [PHONES]
Insert FX
Insert FX
FX REC (OFF)
To DAW input
From input on the device
To output on the device
FX REC (ON)
From input on the device
To output on the device
To DAW input
SLOT1
SLOT2
SLOT1
SLOT2
LOOPBACK OFF/ON
USB
*1 The following chart indicates an effect insertion location. *2 The PHONES output setting varies depending
on the monitor mode.
• When the Monitor mode is set to DAW,
OUTPUT 1/2 can be switched.
• When the Monitor mode is set to DJ, OUTPUT
1/2 are mixed.
• Set FX REC ON when recording the DSP effect
processed signal with the DAW.
• Set FX REC OFF when recording a signal without
DSP effect processing with the DAW.