KORG Drumlogue Hybrid Drum Machine - Manual (Page 10)

10
Connecting the AC adapter
1. Connect the DC plug of the included AC adapter to the DC 9V jack on the
rear panel of the drumlogue.
Be sure to use only the included AC adapter. Using any other AC adapter
may cause malfunctions.
2. Connect the plug of the AC adapter to an AC outlet.
Be sure to use an AC outlet of the correct voltage for your AC adapter.
Oher connections
Connect the devices as appropriate that you will use.
Be sure that the power on all of your devices is turned off before you make
connections. Leaving the power on when you make connections may cause
malfunctions, or damage your speaker system and other components.
Audio equipment
AUDIO OUT L/MONO, R jacks (impedance-balanced 6.3 mm TRS phone jacks):
Connect these TRS jacks to a mixer, audio interface, monitor system, etc. Adjust the
volume level using the VOLUME knob.
Headphone jack (6.3 mm stereo phone jack): Connect the headphones here. This
carries the same signal as that of AUDIO OUT L/MONO and R.
MIDI device
MIDI IN, OUT connectors: Use these connectors to connect the drumlogue to an
external MIDI device for exchanging MIDI messages. Make sure that the MIDI
channels are set appropriately ("Connecting Devices via MIDI" p.49).
Computer
USB B port : Connect this to a computer to exchange MIDI messages and data
("Connecting a computer" p.51).
TO DEVICE (USB A) jack :
You can directly connect a device such as a MIDI controller to this unit to play music
("Connecting a computer" p.51).