HP Color LaserJet Pro MFP M182nw - Manual (Page 98)

Table 9-3 The Attention light is blinking (continued)
Error code State of the printer Action
Er/26 The printer has experienced a general
engine error.
Press the Start Mono Copy button to
continue.
If the error repeats, turn off the printer. Wait
30 seconds, and then turn on the printer.
Er/81 Incorrect firmware has been loaded.
Press the Start Mono Copy button to
continue. Load the correct firmware.
Er/82 The printer has experienced a bad code
signature.
Press the Start Mono Copy button to
accept the signature, or press the Cancel
button to stop the upgrade.
Er/83 The printer has canceled a bad code
signature upgrade.
Press the Start Mono Copy button to
continue.
Er/90 The printer has experienced an engine cable
error.
Press the Start Mono Copy button to
continue.
If the error persists, contact HP customer
support.
Er/91 The printer has experienced a scanner cable
error.
Press the Start Mono Copy button to
continue.
If the error persists, contact HP customer
support.
Er/92 The printer has experienced a control-panel
cable error.
Press the Start Mono Copy button to
continue.
If the error persists, contact HP customer
support.
Table 9-4 The Attention light is blinking and the Toner light is on
Error code State of the printer Action
Er/08 The toner cartridge is very low. Replace the toner cartridge.
Er/10 Multiple supplies are low. Replace the supplies.
88 Chapter 9 Solve problems ENWW