NETGEAR GS110EMX 8-Port SmManaged Plus Gigabit Switch - Manual (Page 54)

Customize IGMP Snooping
By default, IGMP snooping is enabled. You can customize the settings for your network.
To customize IGMP snooping:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
4. Enter the switch password.
The default password is
password
. The password is case-sensitive.
The Switch Information page displays.
5. Select System > Multicast
.
The IGMP Snooping Configuration page displays.
6. Make sure that the IGMP Snooping Status Enable
radio button is selected.
By default, the
Enable
radio button is selected.
7. In the VLAN ID Enabled for IGMP Snooping
field, enter a VLAN ID between 1 and
4094.
By default, the VLAN ID is 1.
You can specify a VLAN for IGMP snooping only if you enabled port-based or
802.1Q-based VLANs (see Use VLANS for Traffic Segmentation on page 29).
IGMP snooping functions only on the VLAN that is specified in the
VLAN ID Enabled
for IGMP Snooping
field.
8. (Optional) Select the Validate IGMPv3 IP header
Enable
radio button.
Some network devices might not conform to the IGMPv3 standard. When the Validate
IGMPv3 IP header option is enabled, IGMP messages are required to include TTL =
1, ToS Byte = 0xC0 (Internetwork Control), and the router alert IP option (9404) must
be set. Otherwise, the packets are ignored.
9. (Optional) Select the Block Unknown MultiCast Address Enable
radio button.
When this feature is enabled, multicast packets are forwarded only to the ports that
are in the multicast group learned from IGMP snooping. All unknown multicast
packets are dropped.
User Manual 54 Manage Network Settings
8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS110EMX